Het bericht Concrete brushes and Wire Tine verscheen eerst op BetonTrowel.

Het bericht Liquid screed dapple bar verscheen eerst op BetonTrowel.

Note the ergonomic handle for ease of operation 75 cm double sponge rubber squeegie for clean up following wet concrete saw cutting.

The ergonomic handle is for ease of operation.

Het bericht Concrete Squeegie verscheen eerst op BetonTrowel.

Lightweight aluminum extrusion provides enormous stiffness

Comes complete with worm drive pitch control (Knucklehead), stamp set, and three extendable snap handles (each 1.8 m)

Het bericht Heavy Duty Check Rod verscheen eerst op BetonTrowel.

The heavy duty bumpcutter (or highway straight edge as it is sometimes called) is designed to assist in achieving good “f” numbers and is especially invaluable when making “superflat floors” where near zero tolerances are demanded.

Each part of the floor finishing process can cause disturbance to the floor. the use of dry shake toppings or powerfloats will change the floor tolerance so using the bumpcutter will scrap away the high spots and help move some material into low spots.

The bumpcutter is supplied with outriggers to avoid bowing of the blade.

Het bericht Heavy Duty Bumpcutter verscheen eerst op BetonTrowel.

Much more rigid than a traditional bullfloat. the length and depth of the channel radius float make this an ideal tool to pass over the concrete imediately after screeding as it will improve flatness and tolerances right from the start.

The channel radius has a rounded end for floating and a sharp back edge for cutting.

The longer blades are fitted with our outrigger system for ease of control.

Het bericht Channel Radius Float verscheen eerst op BetonTrowel.

Het bericht 2 Handed Tamper verscheen eerst op BetonTrowel.

• The beton roller tamp quickly levels slab for final finishing or leave as textured surface – ideal for concrete printing operations
• It Pushes down exposed aggregates
• The Roller tamp is supplied with set of three snap handles
• Part # bt36rt with a 36 inch wide tamper
• Part # bt48rt with a 48 inch wide tamper

Het bericht Mesh Twin Roller Tamp verscheen eerst op BetonTrowel.

The big blue finisher is made from highly flexible carbon steel and is an effective concrete sealer leaving the surface very smooth.

In many applications it could be used instead of resorting to a power float finish.

 * Complete with 3 x 1.8 M Extension Handle and Worm Drive pitch control

Het bericht Big Blue Float verscheen eerst op BetonTrowel.

A carbon steel float with fresno brush holder with hard or soft polybristle fibre. float ends are rounded to avoid trail marks.

Used with the worm drive pitch control the forward pass is made with the blade tilted onto it’s back edge to smooth the concrete going forward. On the pull back the handle is rotated in the opposite direction to put the front edge of the blade in contact with the concrete and at the same time this drops the fresno broom so that it makes contact with the concrete. (see video)

The fresno blade can be used without the broom and adaptor kit as an easy float. Inexpensive options as an alternative to using the pitch control are available for attaching the extension handles. (see accessories)

Complete with 3 x 1.8 M Extension Handle and Worm Drive pitch control

Het bericht Fresno Float verscheen eerst op BetonTrowel.